Maintenance - Build Worker BVC1100-18SS Mode D'emploi

MAINTENANCE

1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Clean or replace the filters. (fig.5)
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT!
Clean or change the dust filter regularly for best performance. ALWAYS USE
DUST FILTER FOR DRY VACUUMING. If the machine is used with out the dust filter, the motor
will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filter included is made of high quality material designed to stop small dust
particles. The filter should be used for dry pick-up only. A dry filter is necessary to pick up dust.
If the dust filter is wet, it will clog quickly and be very difficult to clean. Handle the filter carefully
when removing it for cleaning and replacing it. Check the filters for tears or small holes, a small
hole can let dust pass through and out of the cleaner. Do not use a filter with holes or tears,
replace it immediately.
WARNING!
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM CONTAINER.
40