Dry Vacuum Operation; Dry Vacuuming - Build Worker BVC1100-18SS Mode D'emploi

DRY VACUUMING

WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-
BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM
TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. In order to prepare your vacuum for dry vacuuming, make sure the filter is completely covering
the filter cage against the power head. (fig.2 & 3) (Your Wet/Dry Vac comes with the reusable
cloth filter preinstalled, if not, see page 10 for installation instructions.)
3. Place the power head section back on the container, and secure it in place using the latches.
(fig.4)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the larger end of the hose into the vacuum port on the power head. Push the required
attachment onto the free end of the hose or extension. (fig.5)
5. Plug in the power cord into the outlet. (fig.6)
6. Turn the motor on by pressing the switch to the 'I' ON position and begin vacuuming. (fig7)
7. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the
power cord from the outlet.
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
O = OFF I = ON

DRY VACUUM OPERATION

37