Transportation, Storage And Disposal; Technical Data - Husqvarna LC 451S Manuel D'utilisation

• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 15 . (Fig. 52)
• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
Engine
Brand
3
Displacement, cm
Speed, rpm
Nominal engine output, kW
Ignition system
1
The power rating of the engine indicated is the average net output (at specified rpm) of a typical production
engine for the engine model measured to SAE standard J1349/ISO1585. Mass production engines may differ
from this value. Actual power output for the engine installed on the final product will depend on the operating
speed, environmental conditions and other values.
929 - 002 -

Technical data

Transportation, storage and disposal

Technical data
LC 451S
Briggs & Stratton
140
2900
1
2.6@2900
To adjust the speed control and throttle
control
The speed control adjusts the drive speed. The throttle
control adjusts the engine speed.
CAUTION: Do not adjust the speed control
when the engine is on.
1. To adjust the drive speed, turn the adjuster screw
(A) to adjust the length of the cable sheath. Make the
cable sheath shorter to increase the drive speed.
2. If the choke position or stop position cannot be
engaged, adjust the engine speed. Turn the adjuster
screw (B). (Fig. 53)
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
LC 451V LC 551SP
Briggs & Stratton Kawasaki
FJ180V
140 161
2900 2800
2.6@2900 2.9@2800
LC 551VBP
Kawasaki
FJ180V
161
2800
2.9@2800
15