Table des Matières
Publicité
Appendix
Malfunction
No display when switching on
Stripes in the display when
pressing memory button
Measurement interrupted
Measured values extremely high
or extremely low
Pulse value too high or too low
Possible reasons
Batteries inserted incorrectly?
Batteries empty?
Battery compartment dirty?
No measured values saved.
Batteries empty?
Batteries empty?
Was the correct measuring position
maintained?
Did you move during the measurement?
Did you make the measurement directly
after physical exertion?
Corrective action
Check position of batteries
Change batteries
Clean battery compartment
No display when no measured values
are saved
Change batteries
Change batteries
Repeat the measurement paying attenti-
on to the correct body position. Do not
move your arm or speak.
Sit still for 5 minutes and repeat the
measurement.
G
GB-51
Publicité
Chapitres
Table des Matières
