Dutchblue 5060 Mode D'emploi page 9

3. Slide the backrest frame down through the
arm clips and into the seat frame. Make sure
the push pins are fully depressed before
inserting the backrest frame.
4. Fit the left hand arm and the right hand arm
by positioning the axle (smaller diameter)
part of the tube against the hollow tube
across the rear of the seat frame and sliding
into this tube. The push pin will need to be
pushed in (depressed) to allow the arms to be
fully inserted into this tube.
Once fully inserted the push pin will "pop out"
into the formed slot to lock the arm into
position. This prevents the arm from being
removed again without depressing
the push pin.
5. Fit the commode cushion by positioning onto
the seat frame and align the 4 fixing
locations. Fix down using the 4 seat fixing
knobs and tighten. The cushion will have the
commode bucket connectors pre-fitted at the
factory.
Note: this part may come pre-assembled
from the factory.
ENGLISH
dutchblue.com dutchblue.com
9