Dutchblue 5060 Mode D'emploi page 10

6. To install these assemblies insert the
Left and right hand footrest support
Tubes into the seat frame as shown on the
diagram. Ensure the location pins are seated
inside the location grove shown.
Note: The footrest assemblies will come
pre-assembled from the factory.
Adjust the footrest height to suit the
User as shown ensuring that the screw
Lock is fully tightened and the foot supports
are level.
Note: The distance between the footrest and
the seat cushion can be increased further, if
required, by raising the seat height.
To set the seat height adjust the
Caster legs by using the push pins in
The legs and ensure that the push pins
Fully engage the height adjustment
Holes evenly.
7. The Commode Bucket can be pushed into
position from the rear of the chair and is held
in position by the Commode Bucket
Connectors pre-fitted to the
cushion at the factory. The Commode Bucket
lid is for use after the bucket has been
removed from the chair.
10
ENGLISH
dutchblue.com dutchblue.com