Tool Assembly - Milwaukee SAWZALL 6521 Série Manuel De L'utilisateur

To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
Removing and Replacing the Quik-Lok
Fig. 1
1. To remove the Quik-Lok ®
and pull it out.
®
2. To replace the Quik-Lok
push the connector in as far as it will go. Turn the cord nut 1/4 turn
to the right to lock.
Selecting a Blade
Use MILWAUKEE Sawzall ®
selecting a blade, choose the right type and length.
Many types of blades are available for a variety of applications: cutting
metal, wood, nail-embedded wood, scroll cutting, roughing-in, and
contours.
Many lengths are also available. Choose a length long enough to extend
beyond the shoe and your work throughout the stroke. Do not use
blades less than 3-1/2" long since they won't extend beyond the
shoe throughout the stroke.
For best performance and longest life, see "Accessories" to select the
best blade for the job.
®
Quik-Lok Blade Clamp (Fig. 2)
Unplug the tool before changing blades. Be sure the spindle and blade
clamp areas are clean. Metal chips and sawdust may prevent the
®
Quik-Lok Blade Clamp from clamping securely.
Fig. 2
Collar
1. Depending on the job, the blade may be inserted with the teeth
facing up or down. To install a blade, twist collar in the direction of
the arrow while inserting the blade into the clamp until the tang butts
against the collar.
2. Release collar and the spring loaded mechanism will clamp the blade
firmly in place.
3. Twist collar in the opposite direction of the arrow to ensure that the
blade is locked into the clamp.
4. Tug on blade to make sure it is securely locked in place.
5. To remove a blade, twist collar in the direction of the arrow while
pulling on the blade. Be careful when handling hot blades.
page 6
WARNING!
® Cord (Fig. 1)
Cord, turn the cord nut 1/4 turn to the left
Cord, align the connector keyways and
Blades for best performance. When
Blade

TOOL ASSEMBLY

®
Quik-Lok Blade Clamp Maintenance
• Periodically clean dust and debris from the Quik-Lok
with dry compressed air.
• If the collar resists twisting, twist the collar back and forth to shake
debris loose.
• Periodically lubricate Quik-Lok
such as graphite.
Removing broken blades from the Quik-Lok
Unplug the tool before removing blades. Broken blades can be removed
by the following methods.
• Point the tool downward, twist the collar, and shake the tool up and
down (DO NOT turn the tool on while your fingers are holding the
blade clamp open). The shank of the broken blade should drop out of
the clamp.
• If shaking the tool doesn't work...
In most cases, a corner of the broken blade will extend beyond the
blade clamp. Simply twist the collar and pull the broken blade out of
the clamp by this corner.
• If the broken stub doesn't extend far enough to be grabbed by its
corner, use a thin blade with small teeth (such as a metal cutting
blade) to hook the blade that is jammed in the clamp while twisting
the collar and pull it out.
® Blade Clamp
®
Blade Clamp with a dry lubricant
® Blade Clamp