Product Description And Specifications; Intended Use; Product Features; Technical Data - Bosch AdvancedImpact 18 QuickSnap Notice Originale

Use suitable detectors to determine if there are hid-
u
den supply lines or contact the local utility company
for assistance. Contact with electric cables can cause
fire and electric shock. Damaging gas lines can lead to ex-
plosion. Breaking water pipes causes property damage.
Always wait until the power tool has come to a com-
u
plete stop before placing it down. The application tool
can jam and cause you to lose control of the power tool.
In case of damage and improper use of the battery, va-
u
pours may be emitted. The battery can set alight or ex-
plode. Ensure the area is well ventilated and seek medical
attention should you experience any adverse effects. The
vapours may irritate the respiratory system.
Do not open the battery. There is a risk of short-circuit-
u
ing.
The battery can be damaged by pointed objects such
u
as nails or screwdrivers or by force applied externally.
An internal short circuit may occur, causing the battery to
burn, smoke, explode or overheat.
Only use the battery with products from the manufac-
u
turer. This is the only way in which you can protect the
battery against dangerous overload.
Protect the battery against heat, e.g. against
continuous intense sunlight, fire, dirt, water
and moisture. There is a risk of explosion and
short-circuiting.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.

Technical Data

Cordless drill/driver
Article number
Rated voltage
No-load speed
– 1st gear
– 2nd gear
Impact rate at no-load speed
Maximum torque, soft screwdriving applica-
tion according to ISO 5393
Maximum torque, hard screwdriving applica-
tion according to ISO 5393
Max. drilling diameter (first/second gear)
– Steel
– Wood
Bosch Power Tools
Please observe the illustrations at the beginning of this oper-
ating manual.

Intended use

The power tool is intended for tightening and loosening
screws, as well as for drilling in wood, metal, ceramic and
plastic and for impact drilling in brick, concrete and stone.
The power tool can be used with an angle screw adapter, an
off-set angle adapter or a drill chuck adapter.

Product Features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Holder
(2) Torque presetting ring
(3) Operating mode preselection ring
(4) Gear selector switch
(5) Battery release button
(6) Battery
(7) Worklight
(8) Battery charge indicator
(9) Rotational direction switch
(10) On/off switch
(11) Drill chuck adapter
(12) Off-set angle adapter
(13) Angle screw adapter
(14) Handle (insulated gripping surface)
(15) Universal bit holder
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
AdvancedImpact 18 Drill chuck
QuickSnap
3 603 JA3 4..
V= 18
-1
min 0–400
-1
min 0–1350
-1
min 0–20,250
A)
Nm 19
A)
Nm 38
mm 10
mm 30
English | 17
A)
Off-set Angle screw
adapter angle ad- adapter
apter
– –
– –
– –
– –
– –
– –
– –
– –
– –
1 609 92A 4SE | (12.04.2019)
–
–
–
–
–
–
–
–
–