Important Safety Instructions - Epson ELPMBP04 Instructions D'installation

Installation Instructions
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness, or sufficiency of
the information contained in this document.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer's responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer's responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the ELPMBP04 does not exceed
50 lbs (22 kg).
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING:
Do not use this product outdoors.
IMPORTANT ! :
The ELPMBP04 has been designed to be
mounted recessed into a suspended ceiling secured by a
WireVice system.
IMPORTANT ! :
The ELPMBP04 has been designed to
support a single electrical receptacle, a double electrical
receptacle, or both.
NOTE:
It is the installer's responsibility to ensure that the
enclosure is bonded to the ground in the switch box, in
accordance with the National Electric Code, ANSI/
NFPA 70 or Canadian Electrical Code, CSA C22.1.
NOTE:
ELPMBP04 may be used with ELPMBC02 /
ELPMBC03 / ELPMBC04 columns, ELPMBP07 ceiling
plate, and ELPMBPRH projector mount.
--SAVE THESE INSTRUCTIONS--
ELPMBP04
3