Scale Protocol Transferring (Model With Rs-232) - Gram ZFOC Série Manuel D'utilisation

Note:
• User-defined 4~200 seconds at will, the backlight will be on all the time
if you set the time to 200 seconds (display F after setting).
• If the scale enters into the power saving status, the backlight will be off.
• If you want to improve backlight brightness (level 1-level7,level 7 is
brightest), please press
Scale protocol transferring
1. Power on your scale, then you can press
protocol transferring setting.
2. Press the
screen is to show signals BELOW.
CO,D0. Passive sending out.
C1,D1. Wagon balance scale active sending out.
C2,D2. FTP scale active sending out.
You can enter any section you need by pressing
10
key to change.
(model with RS-232)
key for switchover, at that time the left side of display
key to enter into scale
key and press for exit.