Safety Precautions - König Electronic SEC-ALARM100 Mode D'emploi

• Working distance: +/- 60 m (open area)*
• Detecting range: 5~8 m
• Detecting angle: 100° (horizontal) / 80° (vertical)
• Installation height: 1.5 m (recommended)
• Frequency: 433 MHz ±250 kHz
• Dimensions: 6(W) x 5(D) x 9.8(H)cm
Vibrate sensor (figure 4):
• Power: 4.5 VDC (3x battery LR44, included)
• Standby current: <10μA
• Transmission current: <6mA
• Working distance: +/- 60m (open area)*
• Frequency: 433 MHz ±250 kHz
• Alarm volume: 95 dB (0.5m)
• Dimensions: 4.8(W) x 1(D) x 9.9(H)cm
Remote control (figure 5):
• Power: 12 VDC (3x battery LR44, included)
• Standby current: 0
• Transmission current: <10 mA
• Working distance: +/- 30 m (open area)*
• Buttons: on/off
• LED indicator: 1
• Frequency: 433 MHz ±250 kHz
• Dimensions: 3.5(W) x 1.3(D) x 5.2(H)cm
* Working distance of remote control and sensors can vary due to environmental circumstances.

Safety precautions:

Do not expose the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos, brands or brand logos and product names are trademarks or registered trademarks of their
respective holders and are hereby recognised as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
9