Draining The Reservoir; Removing Lime And Mineral Deposits - Hatco Flav-R-Savor Manuel D'installation Et D'utilisation

English
Draining the Water Reservoir
The water reservoir in humidified units must be drained prior to
moving the cabinet as well as during the "Removing Lime and
Mineral Deposits" procedure.
WARNING
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
NOTE: A cooling fan inside the unit will run for a short time after
the unit is turned off.
2. Locate the valve inside the cabinet on the underside of the
ceiling sheet. CAUTION: BURN HAZARD—Ceiling sheet
and water in reservoir are hot during operation. Allow
to cool before draining.
CAUTION
BURN HAZARD: Ceiling sheet and water in reservoir are
hot during operation. Allow to cool before draining.
3. Position a one gallon (four liter) container under the water
outlet to hold the draining water.
4. Turn the valve handle from the horizontal position (closed)
to the vertical postion (open) to drain the reservoir.
5. Once the reservoir is empty, close the valve.
NOTE: If the water used has an excessive amount of lime or
mineral content, follow the REMOVING LIME AND
MINERAL DEPOSITS procedure for periodic cleaning
and deliming of the water reservoir.
NOTE: Unit failure caused by liming or sediment buildup is not
covered under warranty.
Form No. FSHACM-0719

Removing Lime and Mineral Deposits

Use the following procedure for periodic cleaning and de-liming
of the water reservoir in humidified units.
NOTE: The lime and mineral content of the water used for
daily operation will determine how often the deliming
procedure must be performed.
NOTE: Perform this procedure when the unit will not be used
for a period of time, such as the end of the day.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
NOTE: A cooling fan inside the unit will run for a short time
after the unit is turned off.
2. After the unit has cooled down, perform the "Draining the
Water Reservoir" procedure in this section.
3. Fill the water reservoir with a mixture of 75% water and
25% white vinegar. Do not use flavored vinegar.
4. Plug in and turn on the unit.
5. Set both the air temperature and humidity to their highest
settings and allow the unit to run for 60 minutes.
6. Turn off the unit, unplug the power cord, and allow the unit
to cool.
NOTE: A cooling fan inside the unit will run for a short time
after the unit is turned off.
7. Perform the "Draining the Water Reservoir" procedure to
empty the deliming solution from the water reservoir.
8. Continue to fill and drain the water reservoir with clean
water until the deliming solution is rinsed through and the
water discharge is clean.
9. Plug the unit into its power source and fill the reservoir
as usual for daily operation using the procedure in the
OPERATION section of this manual.
11
MAINTENANCE