Programming - Orbit 62001 Mode D'emploi Et D'installation

programming

Set Clock Time and Day of Week.
Set Clock Time and Day of Week.
• Push
· Push and
RESET
reset
settings.
· Push
/
day time
• Push
DAY
top of the display. [See Figure 4]
the M at the top of the display. [See Figure 4]
FIGURE 4
· Push key to move cursor to the desired day of week. Push
next
• Push
NEXT
record. The time of day will begin flashing.
to record. The time of day will begin flashing.
ENTER
· Push and hold the + key to advance the cursor to the current time of day.
• Push and hold the + key to advance the cursor to the current
time of day. Use the - key to go in reverse. When time of day is
Use the - key to go in reverse. When time of day is reached, press the
reached, press the
key to record.
enter
Programming
and keys at the same time to erase the current
keys at the same time to erase the current settings.
OFF
off
key. The display shows a blinking cursor below the M at the
/
key. The display shows a blinking cursor below
TIME
key to move cursor to the desired day of week. Push
ENTER
M T W T F S S 2 n d 3 rd
12:00
AM
Figure 4
key to record.
12
to
enter
12