Teuco Seaside 641 Manuel De L'utilisateur page 14

EN
TR H2O
MANUAL
TR H2O OFF
HI SALT
LOW SALT
VERY HIGH PH
(TR H2O OFF)
VERY HIGH MV
(TR H20 OFF)
14
Amber colour LED
switched ON.
AWT IN MANUAL
MODE. The treatment
of the water regulates
the pH on the basis of
the set value, whilst
the production of
chlorine without inter-
ruption is effectuated
for 20'.
Amber colour LED
switched ON.
The AWT is switched
off and therefore both
the pH and the chlo-
rine content are not
controlled.
Amber colour LED
switched ON.
The quantity of salt in
the water is out of the
recommended range.
Red LED switched ON.
In this case, the AWT
is positioned in OFF
mode waiting for an
external intervention.
This is not a fault, but a
signal of a non-automatic
functioning situation.
The alarm signal stops after 20'
and the system returns to au-
tomatic mode, or manually in-
tervening before the end of the
20' by changing the AWT status
(switched off or in AUTO).
This is not a fault, but a
signal of a non-automatic
functioning situation.
When necessary, change the
AWT status (in MANUAL or in
AUTO).
When there is not enough salt,
add 500g each time and wait
2 hours. Use an accelerated
filtration programme to mix
the water or repeatedly switch
on the hydromassage pump.
Repeat the operation until the
alarm disappears.
If there is too much salt, partial-
ly substitute the water content
(at least 150-200 litres of water
are recommended).
If the pH is very high, manual-
ly correct the pH values by
adding an adequate dose of pH
minus as per the instructions
on the packet and then activate
the AWT in the desired mode.
If the MV value is very high;
that is to say there is an abun-
dance of chlorine in the tub that
could be irritating. If possible,
wait 24 hours or proceed with
the partial substitution of the
water (at least 150-200 litres of
water). If the problem persists
and/or represents itself after
a few days, contact Technical
Assistance.
AUTOMATIC WATER TREATMENT