Adding Salt To The Water - Teuco Seaside 641 Manuel De L'utilisateur

EN
If the suggested corrective actions do not
obtain the desired result, contact the nearest
Authorised Technical Assistance Centre (refer to
the attached list).
ADDING SALT TO THE WATER IN THE
MINIPOOL
Add 500g cooking salt (NaCl) when the display
reads "LOW SALT" and start the "FILTER PLUS"
function on the alarms "MENU" page.
Make sure that the display no longer reads
"LOW SALT" (this might take a few hours).
If "LOW SALT" does not disappear, repeat the
above procedure.
For optimum salt level checks, use a salinity
detector.
CHECKING THE pH LEVEL OF THE WATER
Every month check the chlorine level in the water
using the control kit (quick tester) supplied as
standard.
In the case of excessive or insufficient chlorine,
decrease or respectively increase the value of
the "pH set" to correct the pH value.
The variations set of the pH value on the control
panel could require hours before becoming
operative on the basis of the utilisation conditions
of the mini-pool.
In the case that the pH is less than 5, it is
advisable to partially substitute the content of
water in the mini-pool to speed up the resetting
of the values.
In the case of a large discrepancy between
the values set on the control panel and the
values detected by the strip, contact the nearest
Authorised Technical Assistance Centre (refer to
the attached list).
AUTOMATIC WATER TREATMENT
11