Putting Away For Winter; Check Sacrificial Anode Corrosion; Ph And Orp Probes - Teuco Seaside 641 Manuel De L'utilisateur

EN

PUTTING AWAY FOR WINTER

Switch off power to the system and empty the
pool.
1) – For long periods of time: remove the
probes, making sure to keep the ends wet
(use the original cases, making sure to wet the
sponge as needed).
It is advisable to contact your nearest
Authorised Technical Assistance Centre (see
the attached list) to perform this operation.
2) – For short periods: no special procedures
are required.
Before using the water treatment kit again
after a winter pause, proceed as described
for first-time use.

CHECK SACRIFICIAL ANODE CORROSION

The pool with AWT is equipped with sacrificial anodes to protect against any corrosion caused by the
presence of salt and chlorine: These sacrificial anodes are located inside the electrolytic cell and can be
easily inspected. During checks and maintenance, check the operation of the anodes. If they are very
corroded, the anodes must be replaced. The anode check must be done at least once per year.

PH AND ORP PROBES

Teuco provides a limited guarantee on the PH
and ORP probes since they are considered "wear
items" because they are subject to performance
degradation based on the use and maintenance
conditions and how they are stored during
periods when they are not used. At least once
a year, have them checked by our Technical
Assistance service.
12
PH
ORP
1
ORP
PH
1
AUTOMATIC WATER TREATMENT
2
ORP
sensor
PH
sensor
2
ORP
sensor
PH
sensor