Whirlpool WED7500GW Guide D'utilisation Et D'entretien page 9

TIMED DRY Cycle:
When you select Timed Dry, the default time appears in the
display. Touch "+" and "–" to increase or decrease the time
in 1 minute increments. Touch and hold to change the time
in 5 minute increments.
The default temperature may be changed by touching
Temperature until the desired dry temperature is lit.
5.
Adjust cycle modifiers, if desired
You may adjust different settings,
depending on what you are drying and how
you are going to dry the items. Selecting
Sanitize will override all other modifiers.
See the "Cycle Guide" for detailed
information.
NOTE: Not all options and modifiers are
available with all cycles.
6.
Select any additional options
Add additional options such as Drum Light, Wrinkle Shield
Signal, and/or Damp Dry Signal by touching that option. If
you will be unable to remove the load promptly, select Wrinkle
Shield before touching START/PAUSE.
™
NOTE: Not all options and settings are available with
all cycles.
7.
Touch and hold START/PAUSE
to begin cycle
Touch and hold START/PAUSE to begin the cycle.
8.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has completed
to reduce wrinkling.
Changing the Automatic Cycle settings
to increase or decrease drying time
If all your loads on all Automatic cycles are consistently
less dry or more dry than you would like, you may change
the default settings to increase or decrease the default
dryness level.
Your automatic drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Automatic cycles, not just the current cycle/load. There are
five drying settings, which are displayed using the
LED display:
,
™
0 Much wetter clothes, 30% less drying time.
1 Slightly wetter clothes, 15% less drying time.
2 Factory preset dryness level.
3 Slightly drier clothes, 15% more drying time.
4 Much drier clothes, 30% more drying time.
To change the drying settings:
1. Before starting a cycle, touch and hold DRYNESS
for 6 seconds.
2. Touch DRYNESS to select the dryness level shown
in the time display: 0, 1, 2, 3, or 4.
3. Touch START/PAUSE to save the new dryness
level setting.
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby
mode (power is off) to adjust the default settings.
9