DOMUS LINE SMALLY D-MOTION Manuel D'installation page 7

INSTALLATION MANUAL
- Then connect the light colour dynamic adjustment system to a
safe power supply with 24Vdc stabilised voltage (sold separately)
and with power at least 10% higher than the total load. For the
total load calculation check plate data printed on the product
label.
- If more than one device must be connected to the power supply
unit ensure that the total sum of the power absorbed by the
devices (check the plate data shown on the product label) does
not exceed the maximum power permitted both by the dynamic
adjustment system and by the Converter.
- DOMUS Line guarantees the product only if powered with
Converters and dynamic light adjustment systems supplied by us.
WARNING
The Led MODULE, the power supply cable or any switch used, are
not replaceable, therefore in case of damage the device must be
entirely substituted.
WARRANTY
- The warranty on the device is valid only if powered by a power
supply provided by DOMUS Line. The warranty's general terms
and conditions for this device are available at
www.domusline.com
EN
CAUTION
ONLY SUITABLE FOR DRY LOCATION
CABINET USE ONLY
USE ONLY 24Vdc CLASS 2 POWER SUPPPLY
TYPE IC RECESSED – INHERENTLY PROTECTED
TO REDUCE THE RISK OF FIRE DO NOT INSTALL CLOSER THAN
10mm TO THE CABINET WALL OR IN A COMPARTMENT SMALLER
THAN 300mm BY 300mm