DOMUS LINE SMALLY D-MOTION Manuel D'installation page 5

INSTALLATION MANUAL
This installation manual contains instructions valid for all
configurations of the SMALLY-CUBIT-QUADRUM D-MOTION
device
WARNING
Safety is guaranteed if these instructions are followed and
therefore they must be kept. Installation may require the
involvement of qualified personnel. Before proceeding with
installation of the device, ensure that the environmental conditions
are in conformity with and suitable for the characteristics of the
product. Before any operation on the device disconnect mains
power.
CONFIGURATIONS
The installation and operation instructions in this manual are valid
for all configurations of the SMALLY-CUBIT-QUADRUM D-MOTION
device, between which there are some differences. The SMALLY
Plus , SMALLY XS Plus, CUBIT Plus D-MOTION and QUADRUM Plus
D-MOTION (Plug & Play) models refer to the configurations of the
devices that have a built-in disconnectable power cable. The
SMALLY IP44, SMALLY XS IP44, CUBIT IP44 and QUADRUM Ip44
D-MOTION models refer to the configurations of the splash-proof
devices.
EN
All of the SMALLY D-MOTION models can also be fitted with
hardware for surface installation. The SP configuration refers to the
devices with symmetrical surface support.
The OB configuration refers to the devices with asymmetrical
surface support. The ML configuration refers to devices for for flush
mount installation on 0.7 mm thick (min.) metal surfaces.
FLUSH INSTALLATION ON WOOD PANELS
The SMALLY TWA-CUBIT TWA-QUADRUM D-MOTION collection
devices can be flush mounted either on a pass-through hole or on
a closed-end hole in wood panels.
The installation can be carried out with the light power supply
cable in both an axial or radial position with respect to the
installation surface. In the event of a specific requirement a power
wire exit hole can nevertheless be drilled in other positions as long
as it does not compromise the integrity of the wire and/or the
connector installed on it.
- To flush mount the device, bore a ø 57mm hole ≥ 12mm deep on
the installation surface and then, if necessary, bore a ø ≥ 8mm exit
hole for the power supply cable as illustrated in figure 1.
- Insert the power supply cable (A) into the hole and then install
the light, applying light pressure until it is completely fitted as
illustrated in figure 2.