HARDER & STEENBECK 20A Mode D'emploi page 11

Introduction
Preface
This operating manual applies to type 20A, 25A, 30A, 50A and 100A series compressors. It contains
important information on the safe, correct and economical operation of your compressor.
Important safety instructions
Please read the operating manual carefully prior to commissioning and observe the instructions con-
tained therein!
Warning: immediate commissioning will damage the compressor and can lead to the destruc-
tion of the motor.
Check for transportation damage. The switch should be in the Off (or 0) position prior to commissio-
ning. Please contact the retailer immediately should deficiencies be detected on the unit. Retain the
packaging carton in case guarantee repairs should prove necessary. Units will only be accepted by the
manufacturer in their original packaging and retoure on pallet.
The compressor is subject to strict safety standards and its functionality has been thoroughly inspec-
ted and tested by the manufacturer at the time of leaving the factory. Please heed the following
instructions in this respect.
The unit should only be entrusted to a specialised dealer for repairs.
Never operate the unit with wet or bare feet and do not touch it with wet hands.
Do not tug on the power cable. The compressor should be activated and deactivated in every case
using the push button.
Never leave the compressor running unsupervised.
Children should never be allowed to use the unit.
Protect the compressor against the effects of cold.
Earthing in compliance with safety standards will ensure the electrical safety of the unit. The manu-
facturer bears no liability for any subsequent damage, injury or accidents occurring in the absence of
correct earthing.
The unit is designed for standard national voltage and should only be connected to a correctly instal-
led and earthed electrical socket. Voltage should correspond to the voltage specified on the techni-
cal data label.
The socket to which the unit is connected should be easily accessible to allow speedy disconnection
from the power supply at all times should the need arise.
Unit safety and protective equipment should not be altered or deactivated.
The unit should be disconnected immediately from the mains power supply if unusual noises, odours
or malfunctions are detected during operation. A specialised workshop should be contacted if neces-
sary. The machine should only be used when it is in a perfect operating condition again.
Ensure that the compressor is located in a well-ventilated room and that the air impeller receives an
unhindered supply of air.
The compressor should never be exposed to rain or water spray.
There is a risk of fire and/or explosion if the unit is sprayed with flammable liquids.
Do not use the compressor near exposed fires. Never touch the cylinder head, cooling ribs or pressu-
re line, as these can reach extremely high temperatures.
Keep highly-flammable objects, materials or nylon away from the compressor.
Do not use the compressor if the power cable is damaged or the electrical power connection does not
comply with safety standards.
Never direct the pressure blast towards people or animals.
Ensure that other persons are only permitted to use the compressor after receiving the necessary
instruction.
GB
11