Bosch AXT 22 D Notice Originale page 16

Masquer les pouces Voir aussi pour AXT 22 D:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
16 | English
used. The operator is responsible for
third persons in the working area.
Bosch can assure flawless function-
ing of the machine only when original
accessories are used.
Become familiar with the instruction
manual before attempting to operate
this machine.
Avoid wearing loose-fitting clothing,
hanging cords or ties.
Only operate the machine in open
space (e. g. not too close to a wall or
other fixed objects) and on a firm,
level surface.
Do not operate the machine on paved
or gravel surface where ejected mate-
rial could cause injury.
Before starting the machine, check
that all screws, nuts, bolts and other
fasteners are properly secured and
that guards and screens are in place.
Replace damaged or unreadable
warning and operating labels.
Before starting the machine, make
certain that the chute assembly is
empty.
Keep your face and body away from
the chute assembly.
Do not allow hands or any other part
of the body or clothing inside the
chute assembly, discharge chute or
near any moving part.
Keep proper balance and footing at
all times. Do not overreach. Never
stand at a higher level than the base
of the machine when feeding materi-
al.
Always stand clear of the discharge
zone when operating the machine.
F 016 L81 437 | (23.11.15)
When feeding material into the ma-
chine be extremely careful that piec-
es of metal, rocks, bottles, cans or
other foreign objects are not includ-
ed.
If the cutting mechanism strikes any
foreign object or if the machine
should start making any unusual
noise or vibration, immediately
switch off and allow the cutter to
stop. Remove the plug from the
mains supply and take the following
steps:
– Inspect for damage.
– Replace or repair any damaged parts.
– Check for and tighten any loose parts.
Do not attempt to repair the machine
unless you are qualified to do so.
Do not allow processed material to
build up in the discharge zone; this
may prevent proper discharge which
can result in kickback of material
through the chute assembly.
If the machine becomes clogged,
switch off and allow the cutter to
stop. Remove the plug from the
mains supply before clearing debris.
Check if guards and protective devic-
es are undamaged and properly
mounted. Before using, carry out any
necessary maintenance and repairs.
Do not tamper with the motor speed
control settings. Contact a Bosch ap-
proved service agent if a problem ex-
ists.
Keep the motor cooling vents clean of
debris and other accumulations to
prevent damage to the motor or pos-
sible fire.
Bosch Power Tools

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Axt 25 dAxt 23 tcAxt 25 tcAxt 2550 tc

Table des Matières