ThermoTec AeroFlow MINI 650 Instructions De Montage page 16

Back
16
D
Antifreeze
+
Install
D
Information
!
Factory Reset
To exit the menu, confirm with OK. The Status Display appears.
If Program = "ON", the Antifreeze temperature will activate in-between the
two directly successive time frames.
Example: Time frame 1: 6:00 a.m. to 7:00 a.m. = 22,0 ° C
Time frame 2: 8:00 a.m. to 9:00 a.m. = 23,0 ° C
In the time between time frame 1 and time frame 2 (7:01 a.m. to 7:59 a.m.),
the Antifreeze protection temperature is retained.
Select a Antifreeze temperature between 0 ° C and
1 °C 17 ° C. Confirm with OK. The Antifreeze temperature
can be changed manually at any time in the
Antifreeze
Temperature-overview display and is retained
temporarily until the beginning of the next time
frame. After the preset end time of the next time
frame, the Antifreeze temperature set in this menu is
activated again (and can be changed manually again).
Note:
If "Smart Start" is activated, the AeroFlow® radiator
will start to heat before the next time frame starts.
If "Smart Start" is deactivated, the Antifreeze tempe-
rature is retained until the set start time.
Use this menu to connect the
Prerequisite: Gateway
The Gateway is an optional item and can be purchased via our online shop.
In this menu you will find information about the device, such as the software
version.
Thursday 09:06 This display view shows the main details of your
device.
Firmware:
System ID:
Heater ID:
IDU:
Menu to reset all configurations to factory settings.
ATTENTION: All personal settings made will be lost!
Follow the instructions on the display.
ARE YOU
COMPLETELY SURE?
(!) Keep pressed The
left button
Status Display view then.
to proceed
AeroFlow® heater to your smartphone or tablet.
AeroFlow® heater restarts and you will see the