ThermoTec AeroFlow MINI 650 Instructions De Montage page 14

Boost
Configuration
14
Use the boost function if you want to increase the room temperature quickly. Press OK to activate the boost
function. During boost, the open window detection is deactivated.
The default setting is 30:00 minutes and it will
12:34
not need to press any further button. Use the arrow buttons to set how many
30:00
minutes (selectable in 5-minute steps) the
permanently for the preset time. Press OK to cancel the boost function.
Boost
Open the configuration menu.
Programs ON
Open window detection
Holidays
Use the arrow buttons to switch the programming mode on or off. Confirm
with OK.
When "Programs OFF", the menu item "Programs" is not visible. Then you can
lower and raise the temperature manually by using the arrow buttons in the
"Status Display" menu instead of (see page 11).
The AeroFlow® heater is able to automatically switch off if an open window
detected. In this menu you can switch this function on or off.
Enable or disable the open window detection.
Detection OFF
The AeroFlow® heater can be switched into holiday mode.
In holiday mode, the program (if active) is disabled for the duration of the
absence. If the heater is in manual mode , the preset manual temperature is
disabled for the duration of the absence.
Use the arrow buttons to enter the number of days you
Days out:
are leaving.
OFF
Use the arrow buttons to set the hour of the desired
Return time:
time of return. Confirm with OK.
09:00
After this, set the minute of the return time and
confirm with OK as well.
count down immediately. You do
AeroFlow® heater will heat
is