Connecting Remote Sensors; Max/Min Weather Data - National Geographic 9070710 Mode D'emploi

• The weather forecast is intended for the next 12 hours, it does not necessarily reflect the current
situation.
• The accuracy of a pressure-based weather forecast is about 70% to 75%.
• The pressure unit is selectable in time setting mode (hPa mb, mmHg, inHg).

17 Connecting remote sensors

The Weather Station can display the readings from up to 3 wireless sensors of the same type. Each
radio sensor must be set to a separate channel. Proceed as follows to set the channel:
1. Remove the battery compartment cover of the wireless sensor.
2. Set the channel selection switch to the desired channel (CH1, CH2 or CH3).
3. Re-attach the battery compartment cover.
4. NOTICE! Each connected wireless sensor must be set to a different channel. If only one wire-
less sensor is connected, it should be set to CH1.
5. Press CHANNEL button for about 3 seconds to reset the values and search for a wireless sensor
(RF signal).

18 MAX/MIN Weather data

Maximum and minimum indoor and outdoor temperatures as well as indoor humidity are stored by the
main unit over a period of 24 hours:
1. Press the MEM button repeatedly to display the stored values of the main unit and of the currently
set outdoor sensor one after another.
2. Display sequence: Maximum values (MAX) > Minimum values (MIN) > Current values
3. Press the MEM button for approx. 3 seconds to delete the values of the current recording period.
NOTICE! All values of the current recording period are also deleted with a battery change.
23 / 52