Maintenance Work; Risk Of Injury; Exclusion Of Liability - Steelcase Migration SE Manuel D'utilisation

_______________________________________________________________

7.4 Maintenance work

Only authorised and qualified personnel may carry
out maintenance work. For more information, please
contact our Customer Service Department. (see
Service
).
Before adjusting the height of the desk, make sure
that the desktop is level. If the floor is uneven, align
the desktop with the adjusting screws on the feet.
Ensure that there are no objects in the movement
range of the lift column!
Danger due to voltage!
Contact with voltage can cause
severe injury or death due to electric
shock.
Attach or detach connectors only when

the equipment is de-energised.
 Do not open the housings of the
following components:
- Controller
- Columns
- Control panel

Risk of injury!

Unintentional lifting or lowering of the
desktop may cause injury.
For maintenance work on all non-

electrical components of the desk,
detach the electrical connection of the
height adjustment unit from the mains.
Risk of injury or damage!
The fastening screws could tear if the
desk is lifted by the desktop or the
attached components.
Always take hold of the desk at the

underframe to transport or move it.
20
ATTENTION
9
Risk of damage to lift mechanism!
The values stored in the controller do
not agree with the settings of a
different desk.
After dismantling the desk, e.g. for transport
reasons:
 Reassemble the two side frames
only with the appropriate
desktop cross-member of the
same desk.
Follow the separate assembly

instructions in this regard.
ATTENTION
Using unapproved spare parts may
cause damage to the desk.
 Only components provided by Steelcase
may be used as spare parts. Coordinate
the installation of differing parts with
Steelcase.
Comply with the specified

maintenance and inspection
intervals.

7.4.1 Exclusion of liability

Steelcase assumes no liability or warranty in the
following cases (see
Inadequate monitoring of the product
■
components (functional checks).
Improper maintenance.
■
Maintenance by a third party.
■
Maintenance by unqualified and unauthorised
■
personnel.
Use of components and adaptations that do not
■
originate from Steelcase.
Unapproved modifications to the product with
■
regard to its design and configuration.
Deliberate incorrect operation.
■
Improper use (see
■
Maintenance
Liability, Page 2
):
1.1 Intended Use
).
153310