Memory Control Panel - Steelcase Migration SE Manuel D'utilisation

_______________________________________________________________
Memory
5.2.4 control panel
Four different memory positions can be entered via
the Memory control panel.
Fig. 5-3: Memory control panel version
ATTENTION
Risk of damage to control panel!
Do not lean on the control

panel.
 Do not place any objects on the
control panel.
 Do not pour liquids over the
control panel.
Height adjustment – Memory control panel
Press the appropriate "Up or Down" button

to reach the desired desktop height.
The desktop moves up or down.
=
 Release the "Up or Down" button.
The desktop stops at the desired point. The
=
display indicates the desktop height.
Manual reset of desktop
 Wait for 5 seconds if the desk has just been
connected to the mains.
Press and hold the "Down" button until the

lower end position is reached.
Continue to hold the "Down" button for at

least 3 seconds.
The resetting and initialisation process is
=
starting.
After conclusion of the resetting and

initialisation process, press the "Up" button.
The desired height is reached.
=
14
Operating and adjusting
Releasing the control panel before the
process is completed will interrupt the
manual resetting process and it must be
started anew.
Configuring memory positions
 Press the "Up" or "Down" button until the
desired height is reached.
The display indicates the desktop height
=
(e.g. 73 cm).
 Press the "SAFE" button.
 Press the desired "Memory position"
button (e. g. button "2")
The display indicates S 2.
=
The display indicates the desktop height
after roughly 2 seconds.
Calling up memory positions
Press and hold the corresponding memory

position button (e.g. button "1" or button
"2", etc.)
The desktop is moved until the stored
=
desktop height is reached. The desktop
movement is stopped whenever you release
the button before the memory position has
been reached.
153310