Steelcase Migration SE Manuel D'utilisation page 13

_______________________________________________________________
Releasing the control panel before the
process is completed will interrupt the
manual resetting process and it must be
started anew.
Limiting height adjustability
These settings could limit the desktop
movement range (should there be a rolling
file cabinet under the desk or a set of
shelves above it).
The stopping positions for the rolling file
cabinet become the new bottommost end
position, and the shelf stopping positions
become the new topmost end position.
Use the "Up" or "Down" button to move

the desktop to the lower halve or the upper
halve of the movement range.
 Simultaneously press and hold the "Up" and
"Down" buttons for 10 seconds.
The position is being saved.
=
153310
Operating and adjusting
Resetting to factory settings
This function can be used to reset the DM
system to its factory settings.
 Briefly press the buttons shown below
simultaneously (then release them):
After one second: Simultaneously press and

hold the buttons shown below (the red
signal lamp will be continuously illuminated):
Red light on the signal lamp starts

flashing.
When the red light of the signal lamp is

flashing: Release the buttons shown below:
Green light on the signal lamp starts

flashing slowly.
 Wait 5 seconds: The signal lamp is then
green and flashing faster. Press and hold
the buttons shown below until the desktop
has reached the lowermost position:
The desktop moves slowly downward in

Safety mode, and the signal lamp is
flashing green until the desktop has
reached the lower end position.
A sound is emitted, and the green light goes
=
out.
 Briefly press the button shown below:
Desktop moves upward a short distance.

The DM system has been reset to its factory
=
settings.
13