Disposal Of The Packaging; Requirements On The Installation Location; Electrical Connection - Graef FK 701 Mode D'emploi

Pull the unit out of the cardboard box.
●
Remove the packaging parts.
●
Remove any stickers on the unit (do not remove the type plate).
●

DISPOSAL OF THE PACKAGING

The packaging protects the unit against transport damage. The packaging materi-
als are selected according to the environmental compatibility and disposal-related
aspects and can therefore be recycled. The return of packaging into the material
cycle saves raw material and reduces the waste volume. Dispose of the packaging
material no longer needed at collection points for the "Green Dot" recycling sys-
tem (in Germany).
IMPORTANT!
If possible, keep the original packaging during the guarantee period of the de-
vice in order to be able to properly pack and transport the device in the guaran-
tee case.

REQUIREMENTS ON THE INSTALLATION LOCATION

For safe and fault free operation of the unit, the following requirements of the
installation location have to be met:
The unit has to be placed on a solid, flat, horizontal, and non-slipping surface
●
with a sufficient weight-carrying capacity.
Make sure that the unit cannot topple over.
●
Choose the location in such a way that children cannot reach the hot surface
●
of the unit or the supply lines.
Do not place the appliance on hot surfaces, such as hotplates, or near them.
●
Never use the appliance outdoors, and always keep it in a dry place.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the power cable can be removed
●
easily in case of emergency.

ELECTRICAL CONNECTION

For safe and fault-free operation of the unit, the following requirements have to
be met during the electrical connection:
Before connecting the unit, compare the connecting data (voltage and fre-
●
quency)
on the type plate with those of your energy network. These details must
correspond so that no damage occurs to the unit. In case of doubt ask your
trained electrician.
The socket has to be protected at least by a 10 amps circuit breaker.
●
DE
EN
FR
NL
IT
25