Basic Operation - Sharp PN-465U Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
5
7
8
1. INPUT (Input mode selection)
The menu is displayed. Press
mode, and press
to enter.
* You can select the input terminal by pressing the input
switch of the monitor.
Input mode
PC1 DIGITAL
*1
PC1 input terminal
PC2 ANALOG
PC2 input terminal
PC3 ANALOG
*2
PC3 input terminals
*1
AV1 DIGITAL
AV1 input terminal
AV2 COMPONENT
*2
AV2 input terminals
AV3 VIDEO
AV3 input terminal
*1 Select the terminal for DVI SELECT. (See page 19.)
*2 Select the terminal for BNC SELECT. (See page 19.)
2. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
3. MENU
Displays and turns off the menu screen (see page 17).
4. VOL +/- (Volume adjustment)
Pressing
or
displays the VOLUME menu when the
menu screen is not displayed.
V O L U M E
15
Press
or
to adjust the volume of the sound.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.

Basic Operation

1
3
4
6
or
to select the input
Video
Audio
PC audio input
terminal
AV audio input
terminals
5. BRIGHT +/- (Backlight adjustment)
Pressing
or
displays the BRIGHT menu when the
menu screen is not displayed.
B R I G H T
15
Press
or
to adjust the brightness.
* If you do not press any buttons for about 4 seconds, the
BRIGHT menu automatically disappears.
6. SIZE (Screen size selection)
The menu is displayed.
Press
or
to select the screen size. (See page 16.)
7. DISPLAY
Displays monitor information. The display disappears when
this button is pressed again or disappears automatically after
approximately 15 seconds.
INFORMATION
INPUT MODE
SIZE
COLOR MODE
BRIGHT
VOLUME
ID No.
MODEL
S/N
1 0 2 4 x 7 6 8
8. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB → STD...
• sRGB applies to PC input only.
sRGB is international standard of color representation
specified by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crytal's characteristics and represents color tone
close to its original image.
XXXX/XX/XX XXX
XX:XX:XX
:
PC2 ANALOG
:
WIDE
:
STD
:
15
:
15
:
0
:
PN-465U
:
XXXXXXXX
V: 60 Hz
H: 48.4 kHz
15
E

Publicité

Chapitres

Table des Matières
loading

Table des Matières