Complete Installation; If You Need Assistance Or Service - Whirlpool WOS97ES0ES Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Install Deflector Kit
1. Flex the upper vent piece (C) away from the lower vent piece
(D) to slide the warming drawer deflector (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also be
required to flex the warming drawer deflector (B) and slide
it into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the warming drawer deflector (B) to the lower vent
piece (D) using two #8-18 x 1/4" screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4" screw
is used on each side.
A
1/4
A. #8-18 x
" screws
B. Warming drawer deflector
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x ³⁄
" screw (E) on each side of the vent tab
8
(B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
16
B
D
C
D
C. Upper vent piece
D. Lower vent piece
A
B
C
D. Warming drawer deflector
³⁄
E. #8-18 x
" screw
8
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Oven
1. Turn on power.
2. At first use, set up the clock and any other preferences
if available. For more information, read the Use and Care
Guide.
B
3. Press BROIL on single oven models.
C
NOTE: Press UPPER BROIL or LOWER BROIL on
double oven models.
4. Set the temperature.
5. Press START.
If Oven(s) Does Not Operate, Check the Following:
Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See "Troubleshooting" section in the Use and Care
Guide.
6. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualified technician.
7. Press UPPER CANCEL/LOWER CANCEL on double ovens,
or press CANCEL on single ovens.

If you need Assistance or Service:

Please reference the "Warranty" section of the Use and Care
Guide.

Complete Installation

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wod97es0es

Table des Matières