Complete Installation - Whirlpool IBS124PSS00 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Push against seal area of front frame to push oven into
cabinet.
4. Securely fasten oven to cabinet using the four #8–14 x 1"
screws provided. Insert the screws through holes in mounting
rails. Do not overtighten screws.
A
A. #8–14 x 1" screws
5. Install the continuous-clean panels and side rails.
6. Place upright continuous-clean panel next to oven wall.
7. Match up retaining holes in top of panel to corresponding
retaining holes on the oven wall.
8. Lift and push the top of the side rails into the top retaining
holes of the panel and wall. When the top has locked into
place do the same with the bottom.
9. Install the oven racks.
6
1
2
10. Replace oven door by inserting both hanger arms into the
door.
11. Open the oven door.
You should hear a "click" as the door is set into place.
12. Move the hinge levers back to the locked position.
13. Check that the door is free to open and close. If it is not,
repeat the oven door removal process and installation
procedures. See "Remove Oven Door" section.
14. Reconnect power.
15. On some models, the display panel will light briefly, and "PF"
should appear in the display.
16. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation
1. Turn the oven control knob to the Oven light position. Check
that oven light turns on.
If oven(s) does not operate, check the following:
I
Household fuse is intact and tight; or circuit breaker has
not tripped.
I
Electrical supply is connected.
I
See "Troubleshooting" section in the Use and Care Guide.
2. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat, turn off the oven and contact a
qualified technician.
3. To set clock and other oven functions refer to the Use and
Care Guide.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ibs224psm00Ibs324psw00

Table des Matières