Makita GA5020 Manuel D'instructions page 6

Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
007993
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing loop handle (Accessory)
CAUTION:
Always be sure that the loop handle is installed
•
securely before operation.
1
008049
Always install the loop handle on the tool before
operation. Hold the tool's switch handle and the loop
handle firmly with both hands during operation.
Install the loop handle so that its protrusion will fit into
the matching hole in the gear housing.
Install the bolts and tighten them with the hex wrench.
The loop handle can be installed in two different
directions as shown in the figures whichever is
convenient for your work.
1
2
3
008047
1. Protrusion of
loop handle
2. Matching hole in
gear housing
2
1. Loop handle
2. Hex wrench
3. Bolt
1
3
008048
Installing or removing wheel guard
CAUTION:
When using
•
wheel/Multi-disc, wire wheel brush or cut-off wheel,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
For tool with locking screw type wheel guard
007994
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
For tool with clamp lever type wheel guard
1
008343
6
1. Loop handle
2. Hex wrench
3. Bolt
2
a depressed center
1. Wheel guard
2. Screw
3. Bearing box
1
2
3
1. Bearing box
2
2. Wheel guard
3. Screw
4. Lever
3
4
grinding