Package Contents; Safety - Liemke SPERBER–25 Mode D'emploi

03. PACKAGE CONTENTS

1x Thermal Imager Sperber-25/-35
1x USB cable
1x Pouch with strap
1x Operating Manual

04. SAFETY

The thermal imager is not recommended to be used in high
temperature environment for a long time, if the temperature is too
high, the imager will enter the high-temperature protection state,
and automatically shut down.
The recommended temperature for use is −10°C to +50°C.
> Make sure that the USB port cover is tightly closed when using in
damp environments, e.g. rainy days.
> Under any circumstances (whether on or off), do not expose
the lens of the thermal imager directly to high-intensity radiation
sources (such as the sun, laser, etc.), to avoid irreversible dama-
ge to the device.
Disposal of waste electrical equipment and batteries
Do not dispose of waste electrical equipment and batteries
in the household waste. Please hand them in to your local
recycling centre. Batteries should be fully discharged when
disposed of.
CE marking
ATTENTION!
The lens of the device must not be pointed at any
sources of intense energy, such as laser-emitting
devices or the sun. This may damage the electronic
components in the device. Damage caused by
failure to comply with the operating guidelines is not
covered under warranty.
Before use
A technical inspection of the device is recommended before use.
> Check the external appearance of the device. There should be
no cracks in the casing.
> Check the condition of the lens and eyepiece: There should be
no cracks, greasy spots, dirt or other deposits.
SPERBER-25/-35 · Operating Manual 12 / 2020
The devices are in conformity with the EU
directives:
EMC Directive 2014/35/EU
RoHS Directive 2011/65/EU
E
N
14
–
15