Satellite Radio Tuner Control (Optional); Basic Operation; Category And Channel Search; Direct Access Tuning - Kenwood KDC-MP342U Mode D'emploi

Function of KDC-MP342U

Satellite Radio tuner control (Optional)

Basic Operation

Selecting Satellite Radio source
Press the [SRC] button.
Select the "SAT"/ "SIRIUS"/ "XM" display.
⁄
• You need to register to the service provider to receive
the service by Satellite Radio. Consult the service
provider if "CALL ... TO SUBSCRIBE" appears.
• The radio may take a little time to start receiving after
you select the Satellite Radio source.
• If the signal reception fails, "Acquiring Signal"/ "No Signal"
appears.
Switching Seek Mode
Display Operation
"CHANNEL" Normal manual seeking control.
"PRESET" Search in order of the channels in the Preset memory.
For how to select menu items, refer to <Menu
System> (page 6).
Select the channel
Press the [4] or [¢] button.
Selecting the Preset Band
Press the [FM+] button.
Each time you press the button, the preset band
alternates between the SR1, SR2, SR3 and SR4.
Channel Scan
Press the [FM+] button for at least 2 seconds.
Pressing this button for 2 seconds or longer allows
you to check individual channel for 10 seconds
each. Pressing this button again for 2 seconds or
longer allows you to exit this mode.
Preset Memory
Press the desired [1] — [6] button for at least 2
seconds.
Preset Tuning
Press the desired [1] — [6] button.
14
|
KDC-MP342U/ KDC-MP242U

Category and Channel Search

Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the Search button.
2
Select the Category
Press the [FM+] or [AM–] button.
3
Select the Channel
Press the [4] or [¢] button.
Cancelling Category and Channel Search mode
Press the Search button.
⁄
• You cannot Channel search until the category
information is acquired.
Function of remote control

Direct Access Tuning

Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"Acquiring Signal"/ "No Signal" appears.