Dometic StarLight Série Instructions De Montage Et De Service page 15

Dometic StarLight
7.3 Connecting the device to the gas supply
WARNING! Beware of injury
!
 This device may only be connected to the gas supply by a spe-
cialist in accordance with the applicable guidelines and stand-
ards (in particular EN 1949).
 Only use propane or butane gas cylinders with an approved
pressure reducing valve and a suitable head. Compare the
pressure information on the type plate with the pressure infor-
mation on the propane or butane gas cylinder.
Observe the following instructions during connection:
 Use gas pipes made from steel 8 x 1 mm (welded, seamless or stain-
less steel), which are flush-mounted with a cutting ring screw assembly.
 Fasten the pipes on the side or rear wall of the surrounding furniture parts
so that no loads are exerted on the actuators.
 The connection must only be able to be released using tools. Observe the
technical regulations on DVGW worksheets G607 and G608.
 The entire pipe system must be free of stress.
 During operation, there must be air vents with a cross-section of at least
2
150 cm in the installation space. These vents can be closed, but must be
kept open when the device is in use.
Connect the device to the gas supply.
➤ Attach a sign above the device with the following text:
"WARNING!
When cooking, provide additional ventilation e.g. by opening windows
near the grill, hob or oven.
This device must not be used for heating the room."
➤ Open the main shut-off valve.
WARNING! Beware of injury
!
Never check for leaks with a naked flame or near sources of igni-
tion.
➤ Check all connections with leak spray.
There are no leaks if no bubbles form.
EN
Installing the device
15