Saey Duo MF Notice D'installation Et D'utilisation page 61

Making fire
Make sure that both the thermal Bimetal and the combustion control lever are to the right
-
If necessary, first clean the ash tray and combustion chamber
-
Place logs of wood in the stove
-
On top of that put some kindling, disperse them and light it.
-
When lighting the fire, leave the door a little open for a few minutes.
-
When you a good fire, close the door firmly with the control handle
-
Continuing to burn
The more we progress in our combustion process, the more the air control lever will be put o the left.
To refill the stove with wood, please re-open the air control lever to the right. You may refill wood
through the filling door on the side, as long as there are no more flames visible. Always open the door
in a gentle manner.
If necessary you can keep the filling door open for a little while until the flames flare up. After 3 minutes,
seal off the door firmly and adjust the air control a little to the middle. The nominal position is now
between the maximum right position and point zero in the middle.
Normally a full load of wood allows you to burn for over 60 minutes, as long as it meets the right
quantity and burning parameters.
Avoid to fill your stove with too much wood, as in this way you will overheat your stove and it will
have a detriment effect on the life expectancy of your stove. Please respect all maximum quantities as
prescribed in chapter 2 of this manual.
61