Command Sms; Troubleshooting - Elbro SMSB221T Manuel De L'utilisateur

SMSB221T - SMS Switch Butler

Command SMS

The device has a series of setup and control commands that are going to be sent by SMS. The command message is protected by a
password (see the system password section). The command message has the following format:
[PASSWORD]#[COMMAND]#[COMMAND]
The following counts for every SMS command:
• The password always has 4 characters
• The hash (#) is obligatory to separate the password from the command itself (only the dot character may be used as an alternative)
Command Description
R1#0 Turns off the relay output 1 (disables AUTO)
R1#1 Turn on the relay output 1 (disables AUTO)
R2#0 Turns off the relay output 2 (disables AUTO)
R2#1 Turn on the relay output 2 (disables AUTO)
? Finds out the current status
A[1-30] Enables the AUTO function and sets the threshold (ex. 20°C)
Comando
Changes the system password
P
Shows the text of the current message
S[1-4]?
Modifies the text of input no.1 contact opening
S1:
Modifies the text of input no. 1 contact closure
S2:
Modifies the text of input no. 2 contact opening
S3:
Modifies the text of input no. 2 contact closure
S4:
Shows the list of previous users
U?
Removes a user from the list
U[1-6]-
Adds or modifies the specified user
U[1-6]:[num]

Troubleshooting

If a fault occurs, the Status-LED will flash red. Count the number of flashes to identify the error code as indicated in the table below:
Flashing Code Description
1
GSM signal is not detected
2
The SIM card is protected by a PIN code
3
No SIM card present
4
The SIM card does not work/is defect
5
System error: Restart the device
6
The SIM card is protected by a PUK code
for example: 0000#R1#1 (turn relay 1 on)
Example
0000#R1#0
0000#R1#1
0000#R2#0
0000#R2#1
0000#?
0000#A20
Esempio
0000#P1234
0000#S1?
0000#S1:input 1 opened
0000#S2:input 1 closed
0000#S3:input 2 opened
0000#S4:input 2 closed
0000#U?
0000#U2-
0000#U1:+0012345678
de de
en en
Answer
fr fr
R1:OFF
R1:ON
it it
R2:OFF
R2:ON
Current status
Th: 20C
Risposta
new Password 1234
7
de en