Inserting The Sim Card; Connecting The Digital Alarm Iiputs; Connecting The External Sensor (Not Included); Connecting The Gsm Antenna - Elbro SMSB221T Manuel De L'utilisateur

Inserting the SIM card

Please obey the following:
• It is allowed to leave the PIN code on
• Disable the answering machine
To insert the SIM card in the device, remove the front panel by using a screwdriver. Gently lift the front panel to access the SIM card slot.
• Open the SIM-door by pushing it gently upwards and lifting it
• Insert the SIM card in the door with its chip facing the contacts and its diagonal corner in the top-right position
• Lower the door and slide it gently downwards until you hear a «click» and the door ist locked.
Reassemble the front panel to close the device.
The SIM card is always to be inserted and removed with the device TURNED OFF.
The device works with prepaid, subscription and data SIM cards. Data SIM cards however are only enabled for sending and receiving SMS
messages, meaning that the "Phone ring" function cannot be used.
Connecting the Digital Alarm Inputs
The device has two alarm inputs, which send a predefined message to a maximum of six administrators after being activated or deactivated.
Connect the inputs (as illustrated in the installation diagram) to contactors, remote switches and/or electromechanical switches you want to
have monitored. The monitored contact must be free of any potential.

Connecting the external sensor (not included)

Connect the sensor only when the device is turned OFF.
The temperature sensor is to be connected to the analogous input.

Connecting the GSM Antenna

Screw the GSM antenna into the SMA connector as illustrated on the installation diagram.

Connecting the Relay Outputs

The device has two relay outputs which handle power loads of up to 5A (resistive). Follow the installation instructions carefully according to the
data plate indications (see corresponding section).
NOTE: Relay output 1 can be activated via SMS or telephone call or used with automatic temperature functions, relay output 2 can be switched
via SMS only.

Programming

Installing the Programming Software

To install the software, proceed as follows:
• Insert the CD in the CD-ROM drive of the PC
• Wait for the CD-ROM to run automatically. If this feature is disabled, open Explorer, right click on the CD-ROM icon and then click on
AutoPlay
• Click on the "Install" setup icon
Warning: during the software installation procedure it may be necessary to install Microsoft .NET Framework 4. An internet connection may also
be necessary.
4