Gas Conversion - F.Bertazzoni Professional Série Instructions D'installation Et D'utilisation

GAS CONVERSION

GAS CONVERSION
WARNING!
Isolate the appliance's gas and electricity supplies
before performing any maintenance.
The gas conversion procedure involves two steps:
• Replacing the nozzles
• Burner minimum adjustment
WARNING: After performing the above-mentioned
procedures, the technician must apply the label
corresponding to the new gas regulation to replace
the old one. This label is contained in the bag of
spare nozzles.
Step 1: Replacing the nozzles
Proceed as follows to replace the oven burner
nozzle:
1. Open the oven door.
2. Remove any accessories from inside the
oven.
3. Unscrew the fastening screws of the oven
base and remove.
4. Slacken off screws A and B.
5. Remove the burner towards the outside in
order to access the nozzle.
6. Change the nozzle using a 7mm box
spanner.
7. Refi t the burner and the oven base.
Proceed as follows to replace the grill (broiler)
burner nozzle:
1. Open the oven door.
2. Remove any accessories from inside the
oven.
3. Slacken off screw A.
4. Remove the grill burner towards the outside
in order to access the nozzle.
5. Change the nozzle using a 7mm box
spanner.
6. Refi t the grill burner.
/ Installation
EN
13