Troubleshooting; Malfunction Table; Replacing The Bulb In The Oven Ceiling Light; Glass Cover - Junker JB13AA 0 Série Mode D'emploi

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
$

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If your meal is not successful, please refer to section . We have
tested the recipe for you in our cooking studio. Here, you will
find useful cooking tips and tricks for cooking, baking and
roasting.
Malfunction Possible cause Remedy/information
The oven does The circuit
not work. breaker is
defective.
Power cut.
Oven not hot. Dust on the
contacts.
ã=
Risk of electric shock!
Repairs that are not carried out properly are dangerous.
Repairs must only be performed by one of our after-sales
service technicians.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers is
found on the side of the oven door. To save time, you can make
a note of the number of your appliance and the telephone
%
Look in the fuse box to see
if the circuit breaker is
defective.
Check whether the kitchen
light and other kitchen
appliances are working.
Turn the control knobs sev-
eral times to the left and
right.
Fold back both locking levers (figure C). Close the oven
3.
door.
&
ã=
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent damage.
1.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.

Glass cover

You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
number of the after-sales service in the space below, should it
be required.
E no.
O
After-sales service
FD no.
37