dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 18

COMPACT 3.0
EN
Clean any dirt and grease from the hatch area
2
before attaching the EPDM seal. Attach the
30x25 EPDM seal around the rim of the hatch
gap.
HOW TO CUT EPDM GASKET TO AVOID
3
WATER FILTRATION INTO THE CABIN
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
CABIN EXTERIOR: Position the unit in the
4
hatch gap.
CAUTION: When positioning the unit above
the hatch gap, check that the wastewater run-
offs are not blocked by the EPDM seal.
Gasket
Remove
A
Gasket
100 mm Approx. (protection paper)
C
Gasket
18
Air conditioning for vehicles
15 mm
Gasket
Cabin roof
2
Gasket
Sun hatch