Makita LS0714 Manuel D'instruction page 19

2. Bevel angle
(1) 0° bevel angle
Push the carriage toward the guide fence and
tighten two clamp screws to secure the car-
riage. Lower the handle fully and lock it in the
lowered position by pushing in the stopper
pin. Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower
bolt) on the right side of the arm two or three
revolutions counterclockwise to tilt the blade
to the right.
4
2
3
Carefully square the side of the blade with the
top surface of the turn base using the triangu-
lar rule, try-square, etc. by turning the 0°
bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
1
Make sure that the pointer on the arm point to
0° on the bevel scale on the arm holder. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
1
2
003943
1. Lever
1
2. Arm holder
3. 0 degree bevel
angle adjusting
bolt
4. Arm
5
5. Release button
001819
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
003944
1. Bevel scale
3
2. Pointer
3. Screw
(2) 45° bevel angle
Adjust the 45° bevel angle only after perform-
ing 0° bevel angle adjustment. To adjust left
45° bevel angle, loosen the lever and tilt the
blade to the left fully. Make sure that the
pointer on the arm points to 45° on the bevel
scale on the arm holder. If the pointer does
not point to 45°, turn the 45° bevel angle
adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45°.
Adjusting the position of laser line
For model LS0714FL only
1
3
1
WARNING:
• As the tool is plugged when adjusting the position
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
• Never look into the laser beam directly. Direct laser
beam causes damage to your eyes.
• Never apply a blow or impact to the tool. A blow or
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
19
003945
1. Left 45 degrees
bevel angle
adjusting bolt
1
005701
1. Work piece
2. Cutting line
3. Holder assem-
bly (optional
accessory)
2
005702
1. Vertical vise
2. Holder assem-
bly (optional
accessory)
2