Makita LS0714 Manuel D'instruction page 14

Example:
In the case of cutting 52/38° type crown mold-
ing for position (1) in Fig. A:
• Tilt and secure bevel angle setting to
33.9° LEFT.
• Adjust and secure miter angle setting to
31.6° RIGHT.
• Lay crown molding with its broad back
(hidden) surface down on the turn base
with its CEILING CONTACT EDGE
against the guide fence on the saw.
• The finished piece to be used will
always be on the LEFT side of the blade
after the cut has been made.
In the case of right bevel cut
Table (A)
Molding
position in
52/38˚ type
Fig. A
(1)
For inside
corner
(2)
Right 33.9˚ Right 30˚
(3)
For outside
corner
(4)
Table (B)
Molding
Molding edge against
position in
Fig. A
Wall contact edge should be
(1)
against guide fence.
For inside
corner
(2)
Ceiling contact edge should
be against guide fence.
(3)
For
outside
Wall contact edge should be
corner
(4)
against guide fence.
Example:
In the case of cutting 52/38° type crown mold-
ing for position (1) in Fig. A:
• Tilt and secure bevel angle setting to
33.9° RIGHT.
• Adjust and secure miter angle setting to
31.6° RIGHT.
• Lay crown molding with its broad back
(hidden) surface down on the turn base
with its WALL CONTACT EDGE against
the guide fence on the saw.
• The finished piece to be used will
always be on the RIGHT side of the
blade after the cut has been made.
Bevel angle Miter angle
45˚ type
52/38˚ type
Right 31.6˚
Left 31.6˚
Right 31.6˚
Finished piece
guide fence
Finished piece
will be on the
Right side of
blade.
Finished piece
will be on the
Left side of
blade.
006363
45˚ type
Right 35.3˚
Left 35.3˚
Right 35.3˚
006364
14