Panasonic TY-ST103PF9 Manuel D'installation page 4

Leave a space of at least 30 cm (11.8 inches) at the top, left and right, and at least 20 cm (7.9 inches)
at the rear. Also leave some space at the bottom.
• Failing to do so may result in a fire.
Requests regarding handling
1) If the unit is placed in direct sunlight or next to a stove, the light and heat may cause discoloration or
deformation.
2) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is particularly
dirty, clean it using a cloth soaked with water to which a small amount of neutral detergent has been
added, and then wipe with a dry cloth. Do not use products such as solvents, thinner or household wax
for cleaning, as they can damage the surface coating. (If using a chemically-treated cloth, follow the
instructions supplied with the cloth.)
3) Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty.
Points to note during installation
● In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in any
of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
● Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily accessible.
● Provide adequate ventilation so that the temperature around the display does not rise above 40 °C (104
°F). If there is insufficient movement of the air inside display, heat may build up inside the display, and fire
may result.
● Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
● Spread a soft blanket or cloth over the floor so that the stand and floor will not be marked or scratched
during the assembly and installation work.
● Perform the assembly and installation work on a flat and level surface, and follow the assembly and
installation work instructions.
● When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
● Take sufficient care to ensure safety around you when performing the assembly and installation work or
while moving about during the course of the work.
● Be sure to read and observe the "Precautions with regard to setting up".
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
17