Panasonic TY-ST103PF9 Manuel D'installation page 10

Getting the hexagon bolts ready
Get the hexagon bolts ready by passing them through the spring washers
and flat washers in this order.
Caution
Use a tightening torque of 7 Nm to 9 Nm for the hexagon
bolts.
2. Use the plasma display mounting hexagon
bolts  (2 at the left and 2 at the right) to
securely fasten both the grounding plates
 and plasma display from the back of the
supports.
● The grounding plates  and plasma display
mounting hexagon bolts  are provided as
accessory parts of the frame.
4. Wiring the equipment to be connected
● For details on how to install the equipment to be connected with the display or adding more equipment, refer to the
operating instructions of the plasma display and the operating instructions of the equipment concerned.
1. If the equipment to be connected (such as
an AV amplifier and DVD recorder) is to be
installed at the same time for use, connect
the plasma display wires first.
2. In connecting the wires of the antenna and
equipment to be connected, and lead them
out from underneath the metal frame.
Run the cords along the clamper of the
wiring metal piece under the back of the
metal frame, and lead them out from behind
the metal frame.
3. Run the power cord through either the left
or right light shield groove.
Caution
Do not bundle the connection cables and main lead
together.
(4 sets each of display mounting hexagon bolts

)
Grounding plates 
Display mounting hexagon
bolts (M8×130) 
Clamper
Metal frame for wiring
23