Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
5. Use the rear cover mounting screw (x1) to
secure the rear cover.
6. When securing the pedestal using only
anchor bolts, proceed to Step 8 "Mounting
the front cover".
2. Securing with wires or chains
1. Use the rear cover mounting screw (x1) to
secure the rear cover.
2. Refer to 1. Securing with anchor bolts ,
then move the pedestal to the installation
location, lock the casters, and adjust the
tilting.
3. Remove the two eye-bolt caps at the left and
right of the rear panel.
4. Attach the eye-bolts wherever the eye-bolt
caps were removed.
5. Attach the eye-bolt caps wherever the eye-
bolts were removed.
6. Fix it like an illustration.
● Use strong wires or chains (with a breaking strength
of at least 1.2 tones, commercially available) and
fasten the plasma display to a sturdy wall, pillar, etc.
firmly enough so that it will not come loose.
26
Eye-bolt
Eye-bolt caps
Rear cover mounting
screw (M5×35)
Rear cover mounting
screw (M5×35)
Publicité
Table des Matières
