WMF LINEO Mode D'emploi page 14

Keep-warm function
(only version with teapot)
In order to keep the finished brewed coffee at a serving temperature, your device is
equipped with a keep-warm function. The keep warm time is set to 20 minutes by
default. appears in the display with the brewing process.
Before beginning the brewing process, you can increase the keep warm time to 40
minutes by pressing the button once or you can deactivate the keep warm function
by pressing the button a second time.
The selected keep warm time is confirmed by pressing the button or the start /
stop button.
Note: If you wait longer than 5 seconds to confirm, the device reverts back to the
standard 20 minutes.
Note: The changed keep warm time is only valid for this brewing process.
Before coffee can be made again, the device should cool down for 5 minutes.
Information about the Cromargan® vacuum jug
(only version with vacuum jug)
The pot is designed as a serving pot and best keeps the content warm when it is full.
The keep warm time can be significantly reduced if it is only partially full or has
residual amounts. It is best if the pot is rinsed with hot water before preparation.
For technical reasons, the seal from the brewing lid is not 100% tight so that it can
be easily opened, even after the coffee cools down. To close, only slightly tighten the
lid. Only used the filled pot standing upright.
To pour, press the pour button on the handle.
To open the pot, turn the lid slightly counter-clockwise. After closing the lid, ensure
that the pour button lines up with the pot handle.
The double-walled Cromargan® container is absolutely break-proof. Nevertheless, it
should be protected against mechanical stresses.
Rinse the pot regularly. If iron particles from water accumulate on the Cromargan®
surface, they can create pitting at those points. Therefore, remove these deposits
immediately with a stainless steel cleanser.
14