AXIS M3011/M3014 Installation Guide
Install the camera
1. Check the package contents against the table on page 3.
2. Drill a hole (70-76mm, 2.75 - 3 inches) in the ceiling to fit the camera's metal camera module
holder.
3. Remove the camera from the metal camera module holder.
4. Carefully push and set the three springs on the metal
camera module holder back into their slots.
5. Pull the network cable through the ceiling and through
the camera's metal camera module holder.
6. Insert the metal camera module holder through the
ceiling. Ensure that Viewing area marked on the rim of the
cup faces the area that is to be monitored.
7. Fix the metal camera module holder into the ceiling. Insert an
instrument such as a screw driver into the metal camera module
holder and release the springs so they clamp down on the ceiling
and hold the cup in place.
8. Attach the cable to the network connector (supports PoE class 1) in
the camera. If PoE is not supported by the network switch, use the
supplied PoE midspan/power injector to connect power to the AXIS M3011/M3014 Network
Camera.
9. Check that the indicator LEDs indicate the correct conditions. See the table on page 13 for
further details.
10. Align the camera arrow with the camera module holder arrow and insert the camera into the
metal camera module holder.
11. Turn the camera so that the camera arrow points to Viewing area marked on the rim of the
metal camera module holder.
12. Proceed to Assign the IP address, on page 6.
Note:
If the camera module holder is mounted onto a hard ceiling such as metal or wood, the
metal camera module holder can be screwed onto the ceiling, and the springs can be
removed.
camera module
holder arrow
camera arrow
Page 5