Axis M3011 Guide De L'utilisateur page 12

Page 12
Setting the IP address with ARP/Ping
1. Acquire an IP address on the same network segment your computer is connected to.
2. Locate the serial number (S/N) on the AXIS M3011/M3014 Network Camera product label.
In Command Prompt enter the following commands (as appropriate for your operating system):
Windows syntax
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
Windows example
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
UNIX/Linux/Mac syntax
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
UNIX/Linux/Mac example:
arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 192.168.0.125
3. Check that the network cable is connected to the camera. Start/restart the camera by
disconnecting and reconnecting power.
4. Close the Command prompt when you see 'Reply from 192.168.0.125:...' or similar.
5. Start your browser, type in http://<IP address> in the Location/Address field and press Enter on
your keyboard.
6. See page 9 for instructions on how to set the password.
Note:
• To open a command prompt in Windows - select Run... from the Start menu, and type cmd (or
command in Windows 98/ME). Click OK.
• To use the ARP command on a Mac OS X, use the Terminal utility, which is found under Application >
Utilities.
AXIS M3011/M3014 Installation Guide