Installation; Accessories; Installation Procedure - Kenwood LZ-7500 Mode D'emploi

Installation

Accessories

A
B
C
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the
accessories shipped with the unit, as shown above.

Installation Procedure

1
To prevent short circuits, remove the key from the
ignition and disconnect the · terminal of the battery.
2
Make the proper input and output cable connections
for each unit.
3
Connect the wiring harness cables in the following
order: ground, ignition.
4
Connect the wiring harness connector to the unit.
5
Install the unit in your car.
6 Reconnect the · terminal of the battery.
2WARNING
• This product is intended for use with 12V DC negative
ground power only. Do not connect it to any other power
supply
• To prevent shorting, disconnect the battery cable from
the negative terminal of the battery during installation.
• Be sure to firmly stabilise this product. Do not install it in
a location which is not stable.
• Follow the installation and wiring procedures described
in this manual. Improper wiring or modified installation
can not only result in malfunction or damage to the unit
but may also result in an accident.
• Do not install the unit in the following locations.
• A location which interferes with the operation of the
air bag system.
• A location which is not made of plastic.
\ Installing on leather, wood or cloth may damage
the surface.
• A location subject to direct sunlight, subject to the air
from the air conditioner, or subject to moisture or high
temperature.
\ This may cause deformation of the monitor unit.
• Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy
parts inside the unit causing it to smoke. Using screws
shorter than those supplied may cause the unit to come
looks from the installation bracket.
• If you are not going to install the unit using the supplied
monitor stand, be sure to use a commercially available
monitor stand. (Mounting holes for such a stand are
located on the bottom of the monitor unit.)
8 - English
D
E
F
(Ø4 x 16 mm)
2CAUTION
• If your car's ignition does not come with an ACC
position, connect the ignition cables to a power source
that can be turned on and off with the ignition key. If you
connect the ignition wire to a power source that receives
a constant voltage supply, as with battery cables, the
battery may die.
• If the fuse blows, first make sure that the cables have
not caused a short circuit, then replace the old fuse with
one with the same rating.
• Do not let unconnected cables or terminals touch metal
on the car or anything else conducting electricity. To
prevent short circuits do not remove the caps from
unused terminals or from the ends of the unconnected
cables.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Insulate unconnected cables with vinyl tape or other
similar material.
• Thoroughly wipe away oil and other dirt from the
installation surface. Please avoid installation on uneven
surfaces.
G
H
(Ø4 x 12 mm)
I